Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Polaris?
Spring replacement in Polaris typically costs $180 – $340 to replace one torsion or extension spring. Because springs work as a matched pair and usually fail within a short time of each other, most homeowners end up replacing both, which puts a typical pair at roughly $360 – $680. That estimate covers the spring itself, the labor to unwind the old one safely, and a balance check on the door; the written estimate you get before any work starts sets the final price.
We handle spring replacement as a core specialty, not a side job. Springs are the single most dangerous part of a garage door system, and they’re the repair most often botched by someone without the right tooling and training. If your door has stopped opening, or you heard a loud snap from the ceiling of the garage, call us at (833) 842-9208 for a free estimate. We can often get eyes on it the same day.
Key Takeaways
- One spring: $180 – $340. A matched pair: about $360 – $680.
- Springs are under extreme tension and should only be handled by a trained technician.
- Most Polaris-area doors use torsion springs mounted above the door; older builds sometimes still run extension springs along the tracks.
- Cold Ohio winters work springs hard, and a failure usually happens on the first cold morning of the season.
- We stock parts for the brands installed across the Polaris area, so many jobs are finished in one visit.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers break down for spring work in the Polaris market. These are typical estimated ranges for 2026, and every job gets a written estimate before we touch the door.
| Job | Typical Estimated Range |
|---|---|
| Single torsion or extension spring replacement | $180 – $340 |
| Matched pair of springs (both replaced together) | $360 – $680 |
| Cable repair (often needed when a spring fails) | $130 – $250 |
| Roller replacement (while we’re in the door) | $110 – $220 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| New door installation (when a repair turns into a rebuild) | $700 – $2,200 |
| General garage door repair | $150 – $600 |
What pushes the spring job toward the top of that range? Spring size and wire gauge, whether the door uses one spring or two, whether the cables and drums show wear, and how accessible the spring assembly is. A high-lift or unusually heavy door needs a spring rated for more cycles, and that costs a little more than a standard residential spring. What keeps it low? A straightforward single-spring door on a standard seven-foot opening where nothing else is worn. The cable and roller line items above are separate work, and we’ll only recommend them when the parts actually need replacing.
For a full picture of what every repair on a garage door costs, our garage door repair in Polaris page covers the rest of the lineup.
What Affects Spring Replacement Pricing in Polaris
Pricing on a spring job isn’t one flat number. Several things move it up or down, and most of them are specific to the door in front of us and the climate it works in.
- Number of springs. Many modern doors use two torsion springs that share the load. Replacing both at once costs about twice a single spring, but it’s almost always the right call because a fresh spring paired with a tired one wears the new one out faster.
- Spring type and cycle rating. Torsion springs mounted above the door are standard on newer builds around Polaris; older homes sometimes still have extension springs running along the track. Torsion springs cost more because the work is more technical and needs proper winding bars, but they last longer.
- Cold-weather wear. Central Ohio swings from humid summers to hard freezes, and the contraction on the first cold snap of the year is when a worn spring tends to let go. Higher-cycle springs make more sense on a door that gets opened several times a day.
- Door weight and size. A single-car door and a double-car door don’t take the same spring. Heavier insulated doors and doors with glass panels need higher-rated springs, which sit at the upper end of the range.
- Condition of the cables and drums. When a spring breaks, the cable on that side can kink or come off the drum. Replacing a cable alongside the spring (from $130 – $250) is common and worth doing in the same visit rather than paying for a second trip.
- Access and overhead clearance. Low headroom above the door, a tight ceiling, or a door that’s been modified can add time. When the hardware is hard to reach safely, we’ll say so up front.
One thing that keeps the price honest in Polaris: we work exclusively on garage doors, so the technician isn’t splitting time between doors, decks, and drywall. That focus means a spring job is diagnosed and finished efficiently. We handle the industry’s leading brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so the hardware in your home is familiar territory rather than a learning curve.
Why spring repair is a job for a specialist
A torsion spring holds hundreds of pounds of force even on a standard door, and it’s stored energy that releases instantly. Winding or unwinding one with the wrong bars, or without knowing how to lock the door and secure the assembly, can cause serious injury. This is the repair we always steer homeowners away from doing themselves. We carry cable repair as well, since a snapped cable and a failed spring often go together.
If you’re not sure whether the spring is the problem or the opener, our opener repair page walks through the symptoms. A door that won’t lift, feels dead when you pull the handle, or makes the opener strain and click usually has a spring issue, not an opener issue.
How to Save on Spring Replacement
You can’t avoid the cost of a failed spring, but you can avoid paying more than you need to. A few practical moves help.
- Replace both springs at once when one breaks. A pair at about $360 – $680 is cheaper than replacing one spring now and the second one a few months later, which means paying the service cost twice.
- Bundle worn parts in one visit. If the rollers or cables are showing age while we’re already in the door, replacing them in the same appointment saves a return-trip charge.
- Ask for the cycle rating. A higher-cycle spring costs a bit more up front but lasts longer on a door that opens and closes several times a day. If you have a busy household, it’s usually worth it.
- Get a free written estimate before any work. A clear estimate tells you the spring price, the labor, and any add-ons separately, so nothing shows up on the bill that wasn’t agreed to. Call (833) 842-9208 for a free estimate.
- Don’t wait through a partial failure. A spring that’s stretched, sagging, or leaving a gap in its coils is on its way out. Catching it before it snaps lets you plan the job instead of forcing an urgent call.
Watch for the warning signs
A door that lifts about a foot and stops, feels unusually heavy, or won’t stay in the open position is telling you the spring has gone. You may also see a visible gap in the spring coils or find the door sitting crooked with one side high. When that happens, stop running the opener; the motor is fighting a door it can’t lift, and it can burn out. Call us and we’ll get you a free estimate at (833) 842-9208. Same-day service is often available so a broken spring doesn’t leave your main entry blocked all week.
Spring Replacement FAQs
How much does spring replacement cost in Polaris?
A single spring runs about $180 – $340, and a matched pair runs roughly $360 – $680. Most homeowners replace both together, so budget for the pair unless only one spring is worn. Call (833) 842-9208 for an exact quote, since estimates are free.
Can you replace a garage door spring the same day?
In most cases, yes. Spring replacement is often a same-day job when you call early, because we stock the common springs and parts for the major door brands and carry them on the truck. That means fewer diagnosis-then-return trips. Call (833) 842-9208 to check availability for the current day.
Is it cheaper to repair or replace a garage door with a broken spring?
Repair is almost always cheaper. A spring replacement at $180 – $340 (or a pair at $360 – $680) is a fraction of a new door installation, which runs $700 – $2,200. Replace the whole door only when the panels, tracks, or frame are structurally worn, not just the spring. Call (833) 842-9208 and we’ll tell you honestly which makes sense for your door.
Why do garage door springs break more in a Polaris winter?
Central Ohio’s cold snaps are hard on springs. Metal contracts as temperatures drop, and the first freeze of the season puts extra stress on a spring that’s already near the end of its life. That’s why we see a run of spring failures on the coldest mornings. A higher-cycle spring handles the temperature swings better. Call (833) 842-9208 for a free estimate.
Do you work on the brands I already have?
Yes. We’re certified to service eight of the most widely installed garage door and opener brands in North America, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Our technicians have up to 11 years of experience and work only on garage doors. Call (833) 842-9208 to book an estimate.
What if the spring broke and took the cable with it?
Cable repair is a separate line item, typically $130 – $250, and it’s common after a spring failure because the sudden slack can kink the cable or pull it off the drum. We’ll inspect both cables and both drums as part of the spring job and quote any cable work before starting. Call (833) 842-9208 so we can look at it together.
Will you need to replace the opener too?
Not usually. A broken spring doesn’t break the opener, though running a strained opener against a door it can’t lift can wear the motor or gears over time. If the opener is showing its own trouble, opener repair runs $120 – $320, and a new opener with installation is $250 – $550. Call (833) 842-9208 and we’ll check both the spring and the opener in one visit.
How do I know if I have one spring or two?
Look at the shaft above the door, not the tracks along the sides. A torsion system has a steel tube running across the header with the spring coils wrapped around it. One spring and you’re in the single-spring range; two springs, one on each side of a center plate, means the pair price applies. If your springs run along the horizontal tracks on each side instead, that’s an extension setup. Call (833) 842-9208 and we’ll confirm from a quick look.
What to Have Ready When You Call
A few details speed the estimate along: the door’s width and height, roughly how old the door is, and whether you’ve seen one spring or two above the door. Note whether the door is insulated and whether it has glass panels, since heavier doors take higher-rated springs. If you know the door or opener brand, tell us; we service the major names, so it’s a detail we can put to work. None of this is required, but it helps us give you a tighter estimate over the phone.
What a typical spring job involves
When a technician arrives, the first step is a full inspection of the door system: springs, cables, drums, rollers, tracks, and hinges. Then the old spring is released safely and measured to match the correct replacement. The new spring is wound to the proper tension, and the door is balanced and tested through a full open and close cycle. If anything else shows wear, you’ll get a quote before it’s added. Most jobs finish in a single visit, and the written estimate sets the final price.
Why we focus on springs
Plenty of companies will change a spring. Far fewer do it every week and understand the specific hardware in a customer’s home. Because we’re a dedicated garage door specialist rather than a general contractor who also handles doors, spring replacement is front-line work for our team, not an occasional side task. That’s the difference between a door that’s balanced and quiet and one that keeps giving you trouble. If a repair turns out to be more than a repair, and the door really does need replacing, we also handle full installation, so you’re not handed off to a second company. We install doors from Clopay, Amarr, Wayne Dalton, and Raynor.
For property managers and landlords in the Polaris area, the same one-visit efficiency matters across multiple units. A worn spring in one door is a sign to check the others, and we can work through a set of doors in a scheduled block. Call (833) 842-9208 to schedule.
Contact Us
If your door has stopped working or you’ve heard the snap of a broken spring, don’t wait on it. Call Garage Door Repair Polaris at (833) 842-9208 for a free estimate. We’ll give you a straight price for the repair, explain what the door needs, and get the spring replacement done right. Free estimates, upfront pricing, and a satisfaction guarantee come standard on every job.
Related Services and Local Guides
- track realignment in Polaris when a door is pulling crooked after a spring failure.
- roller replacement to quiet a noisy door while the spring is off.
- panel replacement for a door that took an impact.
- opener installation when the motor is the next thing to go.
- new garage door installation when a repair isn’t the answer.
- parts supply for brand-specific hardware.
- spring replacement in Lewis Center, the next town over.
- garage door repair in Westerville.
- garage door repair in Dublin.
- garage door repair in Worthington.
Pricing reflects the Polaris market as of 2026. Garage Door Repair Polaris offers free estimates – call (833) 842-9208.
Written by the team at Garage Door Repair Polaris.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Allen Kim"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Steve Whitaker"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Shannon Quinn